A320 FMGS B47

[OmniAtlas]

Thanks for the tutorial. For some reason, however, I can't make it work. I am running the visuals on the same computer as ASN, FSX and JL. For some reason, nothing gets saved in the folder - I would assume that since I am running everything as admin, rights shouldn't be an issue. Any clue what is missing? Is there a setting in ASN, I am lacking?

Is your aircraft moving? Dat weather files do not write (the radar does not 'sweep') until the aircraft moves.

Glad to hear the tutorial helps. I will put up one on intercom next.

[TheLever]

Is your aircraft moving? Dat weather files do not write (the radar does not 'sweep') until the aircraft moves.

Glad to hear the tutorial helps. I will put up one on intercom next.

It did help. I will try to move the a/c, though I don't think that will make the difference - tried it before without any returns. Thanks again for the tutorial, and looking forward to the intercom one

[mikatsan]

Updated feedback:

I Finally made it with weather radar.
The problem was that I had P3D 3.2 and install Jeehell for P3D 3.3

After that the radar worked perfectly with the aircraft NOT moving in the main PC (P3D, ASKY and FMGS)

The problem I have now is that normally the ND runs in a remote computer and cannot "see" the files. I map the WXR drive from the main pc, but the problem is probably that the mapped drive have a different user (main pc's admin) and the ND in the remote runs with the remote pc's admin...

[tuomasho]

Hello,

I just downloaded the new little update for the version number and EIS2 displays... And now I have a problem with both PFD's. The left and bottom parts doesn't show on the displays and resizing doesn't help.

Also I tried both EIS1 and EIS2 setup. EIS1 shows little bit more at left and bottom of display, but neither doesn't do the trick...

Best regards

-=Tuomas=-

IMG_20170323_013334.jpg

[AUA171]

Hi JL!


I installed B47 today. My first test flight was successful without any problems. WXR works great.
One important topic for me is the hardware interface implementation for ACP and WX-Radar panel via SIOC (prefered) or FSUIPC.
I would really appreciate if you could get this done to bring my panels alive


Thanks for your great work!
Christian

[OmniAtlas]

Hi JL -- with the latest update there is now a scaling problem on the PFD regardless if you use EISmodel=2 or 1.

Thank you.

edit -- just realize Tuomas above also mentioned the same thing. Oops

And if you guys didn't know B47 also includes a dimming potentiometer function for the weather and terrain, amazing

[pete_fuss]

Hello JL,
i have found one other issue, the APU EGT did not work correct!
When the APU is starting, the temperatur scala is going to a higher position and after a few seconds, it goes down to 0 Degr, but the APU is still working !
Please have a look.

@OmniAtlas And if you guys didn't know B47 also includes a dimming potentiometer function for the weather and terrain, amazing

Where can i found it?

Regards Peter

[OmniAtlas]

[Fritz]

The assigment for dimming the weather and terrain can be found in FMGS_Config -> DUs Dimmer.

I have an old hardware Panel for the WX Radar. GAIN an TILT are Pots. Will there be an assignment for this too?

What did you have assigned for the release action (Skalarki TQ)? I found manual input flag. Is that correct?

[mikatsan]

@OmniAtlas And if you guys didn't know B47 also includes a dimming potentiometer function for the weather and terrain, amazing

Where can i found it?

Regards Peter

It is in the MCDU Menu page!