A320 FMGS B45

[FlyingTeacher]

Is there an available manual for FMGS?? I tried downloading from website but the PDF a is only 1 page. I'd like to use it on my sim but need install and General directions.

Thank you

[Fritz]

On my last two flights I started to descend after the TOD. It works fine in managed mode.
Contrary to my first committing, this behavior only occurs when the controller instructs to go to a lower altitude before TOD.

[OmniAtlas]

Is there an available manual for FMGS?? I tried downloading from website but the PDF a is only 1 page. I'd like to use it on my sim but need install and General directions.

Thank you

When you install Jeehell FMGS kindly read EN - Installation Guide.pdf and EN - User Guide.pdf

[FlyingTeacher]

When you install Jeehell FMGS kindly read EN - Installation Guide.pdf and EN - User Guide.pdf

No place to get it prior to install??

[Swiss1673]

this was not an error, the aircraft.cfg changed for W&B purpose, you need to put the old weight back. There are new payload stations which are used for some W&B tricks (the adjustement payload stations).

Thanks JL for the clarification! So I have to be careful when I load the Aircraft with TOPCAT. Because its overwriting the exiting weights and usually the aircraft is too light. Which are the stations with the additional Weight for W&B?

Cheers
Daniel

[OmniAtlas]

No place to get it prior to install??

Try and website and explore the resource section.

Www.soarbywire.com

[Leonidas]

On my last two flights I started to descend after the TOD. It works fine in managed mode.
Contrary to my first committing, this behavior only occurs when the controller instructs to go to a lower altitude before TOD.

Something similar happens to me: in cruise phase if I push ALT in FCU without changing altitude (just to turn on the ALT dot LED), the A/C speed down and there is no more CRZ mode in FMA.

[Phpilot]

Hello everyone... I have one question about new version 45. After put the correct qnh , it appear in ecam one mensage of discrepancy altimeter. I ha just Captain side of PFD. How I can fix this? In old version I didn't have this issue. Can you help me? Please
regards
Frederico

[OmniAtlas]

Hello everyone... I have one question about new version 45. After put the correct qnh , it appear in ecam one mensage of discrepancy altimeter. I ha just Captain side of PFD. How I can fix this? In old version I didn't have this issue. Can you help me? Please
regards
Frederico

I have 2 CP flight EFIS and I don't get that message alert even with discrepancy. What is the trigger for the alert?

[Pim van Vrijaldenhoven]

Hi All,

The message appears on the PFD with the Skalarki FCU/EFIS when the QNH difference between CS and F/O is more than x hPA. I did not check the value of x.

Best regards,

--pim