Programming Encoder with SIOC_Creator

[Niklas]

Hi,

I want to programm the HDG Encoder and then I have 2inputs but only one input is asked by SIOC_Creator.
I have the encoder(s) the MasterCard e.g. on Input 100 (Signal A) and 101(Signal B). The middle on GND of the groupe.
Must I just set Input 100 or do I need a special card? And what must I set in the fields Acceleration and Direction?

Thx.
Niklas

[Niklas]

Is my English too bad or does nobody know the answer?

[iwik]

Hi Niklas,
With Master cards the preferred encoder is the CTS288. Using other types of encoders
may produce unpredictable results.
When defining encoder inputs consecutive inputs must be used and you only have to
specify the first input. Sioc automatically uses the next input.
Hope this helps.
Les