Results 1 to 5 of 5
  1. 06-14-2015, 02:23 PM #1
    pablonator3000
    pablonator3000 is offline
    10+ Posting Member pablonator3000's Avatar
    Join Date
    Oct 2014
    Location
    Austria
    Posts
    24
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thrust Lever Problem

    Hello
    I've got a little problem with my Jeehell FMGS Thrust Lever. When I try to start the engines, the ECAM says:" Start Fault, THR Lever not at IDLE ", but it is on IDLE. So I have a Screenshoot to show my problem exactly.
    Yours faithfully Pablo
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 06-14-2015, 05:18 PM #2
    OmniAtlas
    OmniAtlas is offline
    2000+ Poster - Never Leaves the Sim


    OmniAtlas's Avatar
    Join Date
    Jun 2012
    Location
    Sydney, Australia
    Posts
    2,107
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Thrust Lever Problem

    Try using an error zone of 1 in the joystick configure program if you are using the software based throttle lever.
    Soarbywire - Airbus Flight Simulation and Engineering | Jeehell FMGS - Free professional A320 avionics software for the cockpit enthusiast.

    Reply With Quote Reply With Quote
  3. 07-03-2015, 04:41 AM #3
    EdwardInBeijing
    EdwardInBeijing is offline
    25+ Posting Member


    Join Date
    Nov 2014
    Location
    China
    Posts
    61
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Thrust Lever Problem

    I have this too, but a quick wiggle of the throttles clears it. I keep meaning to go into the FMGS_config utility to increase the error margin but it's not high on the list.
    Reply With Quote Reply With Quote
  4. 07-03-2015, 05:52 AM #4
    jeehell
    jeehell is offline
    2000+ Poster - Never Leaves the Sim
    Join Date
    Mar 2008
    Location
    France,Nice
    Posts
    2,652
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Thrust Lever Problem

    Pablo,

    Jut to make sure, you did calibrate the throttle module in the FMGS Config? even if it's software based, it needs the calibration process.

    JL
    Reply With Quote Reply With Quote
  5. 10-29-2019, 02:02 AM #5
    AndiHamburg
    AndiHamburg is offline
    New Member
    Join Date
    Nov 2014
    Location
    Hamburg
    Posts
    1
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Thrust Lever Problem

    I have actual the same problem. I am using the Saitek Throttle Quadrant and Thrustmaster Joystick T.16000M.
    To allocate what device is working wrong, I switched off first Saitek and than Thrustmaster. But the error message is still the same (without any device on PC).
    Furthermore with Throttlequdrant I am not able the increase or decrease power.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »