Encoder trouble

[BlackWidow]

Hello All

OK I have a various assortment of Rotary encoders and Pots. I have hooked each type to my phidgets and no matter which one i use (except for the 60mm sliders that i purchased with my 8/8/8 card ) As soon as I turn the roatry I either enable the USB phidget card or disable it.

For example turning the dial all the way to the left the computer makes the same sound as if I were to unplug the phidgets card USB cable and on the FS2Phidgets software the light turns red if I rotate the dial the opposite direction the computer make the same sound as if I plugged in the USB cable and the FS2Phidgets software shows Green. What am i doing wrong? I have tried wiring the encoder different and have tried every encoder/Pot I have and all of them do this except the slider that came with the 8/8/8 card.

Thanks

Michael

[Bob Reed]

It is not hooked up right. I am not sure what to tell you. You need to find a tutorial and see what you are doing wrong.

[BlackWidow]

I used the cable that came with the sliders it has three wires Black Red White. no matter where i place the (insert color here) wire I get the same result. on the phidgets card I simply plug in the cable and have striped the wires and place them on the encoder.

[Bob Reed]

What are you wiring it to? Rotary encoders need electronics to work. It does not work like a pot. You are trying to hook them to where you hook the pots?

[BlackWidow]

Bob Im not sure what you mean by "electronics to work". one type of rotary I am using says AB Type J (not sure what this means) and another I am using says CLAROSTAT on one side then on the other side it says LSC-805-6 Im sure theses probably mean nothing to you but jus tin case you know what they mean LOL. the second one i described when i frist hooked it up i saw the read out at 28 then it stoped in the FS2 Phidgets software.

[Bob Reed]

Well I do not know a lot about Phidgets, but, they have a rotary encoder controller. You have to use a controller on rotary encoders. Encoders use voltage to track speed and direction and you need the controller to read that data. Here is one of there boards. http://www.trossenrobotics.com/store...igh-Speed.aspx

[Bob Reed]

PLEASE!!!! Tell me I am reading this wrong. It is NOT $55.00 for the controller for 1 encoder??!!!!!!

[BlackWidow]

WOW thats expensive AHHH i see what you mean by electronics. i guess i will be using sliders LOL

[BlackWidow]

ARGHHHHH now when i try to go to configure to see the slider configure page i get a Runtime error 91. AHHHH SIM BUILDING LOL

[Bob Reed]

Reboot the computer....