Results 1 to 6 of 6
-
02-18-2014, 06:06 PM #1
- Join Date
- Jan 2007
- Location
- East Yorkshire UK
- Posts
- 267
Problem with today's update Widefmgsserver
Started up FS and FMGS software just now. Both PC's updated however on restart I get error on Widefmgsserver "Invalid floating point operation". Other than the updates which came down automatically I have not changed anything since the last successful run yesterday. Can anyone advise please?
Barry
-
02-19-2014, 04:52 PM #2
- Join Date
- Mar 2008
- Location
- France,Nice
- Posts
- 2,652
Re: Problem with today's update Widefmgsserver
Hi Barry,
Do you use the last B32 version?(http://www.jeehell.org/A320FMGS_B32.exe)
If you updated, please reinstall the genune B32 package. There apparently are issues with the updater.
JL
-
02-20-2014, 05:31 PM #3
- Join Date
- Jan 2007
- Location
- East Yorkshire UK
- Posts
- 267
Re: Problem with today's update Widefmgsserver
OK I installed the B32 package on two computers and this cleared the problem above. However I now have a new one! The SD and EWD screens on the "slave" PC are only partially drawn, I see needles moving but no background. Other programs on the "slave" work fine (FCU, MCDU,OHD). If I run the SD and EWD on the "Master" (FS) computer the graphics are drawn properly. Have tried re-installing software but no change.
Barry
-
02-20-2014, 07:16 PM #4
- Join Date
- Mar 2008
- Location
- France,Nice
- Posts
- 2,652
Re: Problem with today's update Widefmgsserver
Hi,
This looks like an OpenGL issue. What video card do you have on that computer? Drivers are up to date?
Do you run PFD/ND also on the slave? Any issues with them?
JL
-
02-21-2014, 07:42 AM #5
- Join Date
- Jan 2007
- Location
- East Yorkshire UK
- Posts
- 267
Re: Problem with today's update Widefmgsserver
Card is Radeon 9600, it is an old PC that I am using for testing. All worked fine until I let the FMGS auto update to its work. Although I loaded B32 I think there must have been some elements left in. I stripped all the software out and reloaded, it all works fine again now. Will avoid the auto update in future until I see positive thoughts about it in this forum!
Test flights going well until the final approach when the speed will not drop, thr lock engages and basically all goes wrong. I must be doing something wrong so will try harder.
Barry
-
02-21-2014, 09:59 AM #6
- Join Date
- Mar 2008
- Location
- France,Nice
- Posts
- 2,652
Re: Problem with today's update Widefmgsserver
Barry, if your speed is not reduced in APPR phase, check the following:
- APPR mode engaged in the MCDU (when you go to PERF page, it should show APPR page, otherwise you can force activate it there)
- you use managed speed mode
- you select flaps 1 before descending on the glide, otherwise on a 3° slope, in clean configuration the ACFT cannot decellerate.
- if you're heavy, it can be that VFE of next flap setting is above the manoeuvering speed (S or F speed). In that case, you must use selected speed to slow down, then extend the flaps. You can then resumt managed speed mode.
JL
Search Pretty Womans from your city for night
New Version of UPDNAV for Jeehell...