Results 1 to 10 of 12
Thread: Turning an 8 way into a mouse
-
07-05-2008, 10:14 AM #1
Turning an 8 way into a mouse
Has anyone seen anything on making an eight way switch or a little thumb axes control, like the ones found on CD-Products and others' throttles, into a mouse?
Real fighters often use such a device to move the radar cursor. I would like to make it into a mini mouse. (mini mouse? wasn't that Mickey's GF)
John
System:
ASUS P5Q SE/R
Intel Q9550 O/C to 3.4 GHz
4 GB 1066 DDR2 RAM
300 GB WD 10,000 RPM Raptor SATA Drive
GeForce 8800 GT 512 KB RAM
Matrox TH2Go with three 19" Sumsung 940 BX
IR Track 4
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
Tomlin thanked for this post
-
07-05-2008, 02:48 PM #2
Thanks, I too would like to know about this myself.
-
07-05-2008, 03:51 PM #3
Maybe
I had little success with plugging a joystick into a networked computer and choosing this a s the main human interface device, but could only move the mouse with the x/y axis of the joystick.
-
07-05-2008, 04:39 PM #4
- Join Date
- May 2008
- Location
- Earth
- Posts
- 288
Here is just an idea.
If you have a old ball mouse (not the optical ones), open it and see how it actually works. The ball is connected to a shaft and at one end the shaft is connected to a wheel which has small gaps. These wheel with the gaps then go in between a LED /LED Pick-up sensor. It basically block/unblock the light of the LED on the pick-up.
Now what I would have done is take the two mouse wheels out. Connect the swith of the joystick (Assume a HAT type switch) to an oscillator that flickers the LEDs on/off simulating the movement of the mouse. The frequency of the flicker will determine the speed that the cursor is moving.
Now that I think of it, a mouse sensor probably works like a rotary encoder. It probably has 2 Leds per sensor. Will have to simulate some sort of Gray code. This is an ideal project for a PIC microcontroller or similar.
Hope the idea is clear enough. What do you think?
-
07-05-2008, 04:47 PM #5
- Join Date
- May 2008
- Location
- Earth
- Posts
- 288
Another idea:
The PIC18F4550 or the smaller PIC18F2550 has a USB interface using the HID driver in Windows. One could easy set it up as a USB mouse. When pressing the HAT switch, a mouse movement could be simulated.
Problem with these ideas is that you must be able to program microcontrollers.
-
07-05-2008, 05:17 PM #6
Guess, I am looking for a software solution. What good are those mini joysticks on the end of the throttle for anyway?
Nobody is going to try and FLY the airplane with it.John
System:
ASUS P5Q SE/R
Intel Q9550 O/C to 3.4 GHz
4 GB 1066 DDR2 RAM
300 GB WD 10,000 RPM Raptor SATA Drive
GeForce 8800 GT 512 KB RAM
Matrox TH2Go with three 19" Sumsung 940 BX
IR Track 4
-
07-05-2008, 05:29 PM #7
The hat switch (or Coolie switch) is normally used for looking around.
-
07-05-2008, 06:18 PM #8
This isn't the coolie. It is a two axes mini joystick. It is located on the end of the throttle right under where the thumb falls. I know it is on the CH-Products throttle. I assume it is on (from pictures) the Thrustmaster throttle. It is also on the real F-16 throttle and used to move the cursor on the radar.John
System:
ASUS P5Q SE/R
Intel Q9550 O/C to 3.4 GHz
4 GB 1066 DDR2 RAM
300 GB WD 10,000 RPM Raptor SATA Drive
GeForce 8800 GT 512 KB RAM
Matrox TH2Go with three 19" Sumsung 940 BX
IR Track 4
-
07-06-2008, 12:14 PM #9
For what sim do you need such thing? In Lock On you can edit commands. I have Saitek Evo Cyborg, and hat is by default used for looking around. But I assigned it to move target designator in all 8 directions. And if combined with CTRL, I can move radar scanning zone.
No need for special hardware - just edited the in-game commands.
-
07-06-2008, 08:40 PM #10
If you're looking for a software-based approach to this, check out Pinnacle Game Profiler. It's a generic profiler for game controllers, and it has the ability you're looking for. I'd describe the program as on a par with Saitek's profiler, but it falls short of Ch Products. It lacks support for complex scripting, combining controllers, and setting response curves. That said, it's really quite functional. I was pleasantly surprised to see all that it can do.
It's at least worth a look. It's $20 USD to register, but you can evaluate it for 30 days. I'm pretty sure that you can find some freeware alternatives as well.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
jmig thanked for this post
Similar Threads
-
Turning programs on and off in the FSX Computer.......FSUIPC
By brianwilliamson in forum General Builder Questions All Aircraft TypesReplies: 2Last Post: 05-23-2011, 03:13 AM -
FSX Problem turning into waypoints
By ktroemer in forum PM General Q & AReplies: 9Last Post: 11-28-2009, 06:45 AM -
Turning heading bug fast with rotary encoder
By Learjet15 in forum I/O Interfacing Hardware and SoftwareReplies: 0Last Post: 04-19-2009, 12:47 PM -
Aircraft turning in towards waypoints when very close
By Ray Proudfoot in forum PM General Q & AReplies: 39Last Post: 02-12-2007, 06:52 PM
Prettys Womans from your city for night
A320 Sound Files Missing