Results 1 to 10 of 13
Thread: Opencockpit Airbus radio module
-
06-23-2015, 12:04 AM #1
Opencockpit Airbus radio module
The OC airbus radio module (http://www.opencockpits.com/catalog/...ml?cPath=22_63) looks like a good representation of the one found on the real airbus.
Unfortunately back lighting is controlled by a switch at the back of the panel.
Has anyone successfully integrated the OC radio panel with a 5V lead controlled by the INTEG LT pot?
Thank you,
BenSoarbywire - Airbus Flight Simulation and Engineering | Jeehell FMGS - Free professional A320 avionics software for the cockpit enthusiast.
-
06-23-2015, 02:50 AM #2
Re: Opencockpit Airbus radio module
Ben,
I have not tried any dimming as yet on mine, but it might pay to send an email to Open Cockpits and ask how they have set it up. They are usually helpful if you get the right person to answer you ( sometimes !)
Regards..............Brian W.
-
06-23-2015, 04:46 AM #3
Re: Opencockpit Airbus radio module
Hi Brian,
I got a response from OC, they told me I have to 'short' the switch -- I am not too sure how complicated that process may be, without looking at the circuit, switch.
I would appreciate if you could take a look at your panel and see if it would be possible.
Thank you,
BenSoarbywire - Airbus Flight Simulation and Engineering | Jeehell FMGS - Free professional A320 avionics software for the cockpit enthusiast.
-
06-23-2015, 01:52 PM #4
Re: Opencockpit Airbus radio module
Ok I will take a look at one of the radios today.
From memory, I recall a 2 pin socket on the back of the radio, so all that means that it would be similar to FCU setup, which either has a potentiometer ( 1K to 50 K probably) or a switch connected to those 2 pins.
Regards................Brian W.
-
06-23-2015, 10:31 PM #5
Re: Opencockpit Airbus radio module
Thank you Brian,
Hopefully if all is well I will continue with an order from OC.Soarbywire - Airbus Flight Simulation and Engineering | Jeehell FMGS - Free professional A320 avionics software for the cockpit enthusiast.
-
06-24-2015, 03:42 AM #6
Re: Opencockpit Airbus radio module
Ben, tried a Pot. but it is drawing too much current I suspect, so suggest that a quick email to opencockpits would be the safest bet.
Regards...............Brian W.
-
06-24-2015, 05:05 AM #7
Re: Opencockpit Airbus radio module
Cheers, will do, thanks Brian.
Soarbywire - Airbus Flight Simulation and Engineering | Jeehell FMGS - Free professional A320 avionics software for the cockpit enthusiast.
-
06-27-2015, 10:26 PM #8
Re: Opencockpit Airbus radio module
Ben,
I also sent an email to their help department to see if we can get an answer. It seems as though they use another usb board to do some dimming, for which I am not familiar. It should be a simple job, but knowing Open Cockpits, it will more than likely be a bit more complex !
Have just upgraded the knobs on the RMP's to look a little better.
Regards..................Brian W.
-
06-27-2015, 11:14 PM #9
Re: Opencockpit Airbus radio module
Thanks Brian, your job looks very professional
I am assuming the transponder (backlighting) would also be wired up similarly.Soarbywire - Airbus Flight Simulation and Engineering | Jeehell FMGS - Free professional A320 avionics software for the cockpit enthusiast.
-
06-28-2015, 03:06 AM #10
Re: Opencockpit Airbus radio module
I have not pulled the transponder out yet, as have only just done the knobs for it, but from memory it should be the same.
Regards....................Brian W.
Prettys Womans from your town for night
HDG preselect function