Results 1 to 2 of 2
  1. 09-21-2011, 06:40 PM #1
    No Longer Active
    No Longer Active is offline
    1000+ Poster - Fantastic Contributor
    Join Date
    Nov 2008
    Location
    Europe
    Posts
    1,931
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Linear rod advice.

    Hi All,

    I am building a 13" x 13" cnc machine by precisely following a set of plans and instructions.

    I would like to know if my linear steel rods can be replaced by hollow steel tubes. The amount of money saved is around half.

    I would like to know if steel tubes can be incorporated into a cnc machine instead of steel rods.

    Has anyone ever seen a linear steel tube with bushing in a cnc before?

    Thanks.

    Alex
    GA or the Highway!
    Reply With Quote Reply With Quote
  2. 10-25-2011, 08:19 AM #2
    CLaNZeR
    CLaNZeR is offline
    New Member
    Join Date
    Oct 2011
    Location
    UK
    Posts
    2
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Linear rod advice.

    Hi Alex

    I would stick with the hardened steal rods as they will keep your machine more rigid, where as hollow tubes do tend to bend a little.

    Hardened rods are only around 2.00 for 100mm depending on the thickness from certain suppliers.

    Good luck with your build

    Cheers

    Sean.
    ********************
    http://www.cncdudez.co.uk
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »