Results 1 to 3 of 3
  1. #1
    300+ Forum Addict



    Join Date
    Jan 2009
    Location
    Tampa
    Posts
    487
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Linear Pots ....

    Until very ecently I thought I was familiar with every electronic component ever made. From crystal radio detectors
    made from coal, to the latest micros and FPGAs... but I recently saw a pot that is a cylinder with a shaft coming out one end, and three terminals! it looks like a tiny gas shock! It really caught me by surprise, as it is not really al
    slide pot per se, but a totally different unit than I had ever seen! What a neat gizmo for us builders! Is anyone else (Mike P) familiar with these?



    Buddy

  2. #2
    75+ Posting Member Leo Bodnar's Avatar
    Join Date
    Apr 2008
    Location
    UK
    Posts
    94
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Linear Pots ....

    This is a "linear displacement sensor" used in automotive, motor-racing and similar industries e.g. http://www.pennyandgiles.com/Linear-...94,3,24,16.php
    Basically, it's a linear pot with mechanical life of 10+ mln movements and great environmental protection.
    It should cost about $100-$200 per piece if you are lucky. I have a few just in case world financial system comes to a total collapse.

  3. #3
    300+ Forum Addict



    Join Date
    Jan 2009
    Location
    Tampa
    Posts
    487
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Linear Pots ....

    I guess finding them for $5 is very lucky then.....

Similar Threads

  1. calcs required for linear actuator
    By metalnwood in forum Cockpit Parts and Motion Platforms
    Replies: 5
    Last Post: 04-30-2009, 04:35 AM
  2. Where can I get 5 to 7 inch 100K linear slide pots?
    By Simran737 in forum I/O Interfacing Hardware and Software
    Replies: 5
    Last Post: 04-16-2008, 08:03 PM
  3. Linear vs audio taper pots for flight controls
    By mauriceb in forum I/O Interfacing Hardware and Software
    Replies: 3
    Last Post: 08-13-2007, 11:02 AM
  4. linear or llogarithmic
    By Radar in forum Where to Start Building a Home Cockpit
    Replies: 3
    Last Post: 05-14-2007, 08:39 PM
  5. linear slider pots to use with phidgets 8/8/8/
    By steve diamond in forum Phidgets & Cockpit Simulator Builder
    Replies: 3
    Last Post: 03-28-2006, 05:53 PM