Results 1 to 3 of 3
Thread: FSUIPC Steering Tiller
-
12-22-2009, 04:23 PM #1
- Join Date
- Sep 2007
- Location
- UK
- Posts
- 31
FSUIPC Steering Tiller
I have connected an open cockpits axis card with one axis setup in FSUIPC 3.93 as a steering tiller. This works fine giving smooth direction changes without the need to use the rudder pedals.
However, it seems to also be interfering with the pitch axis. This only becomes apparent at rotation on take-off when a pitch up input has no effect. It is necessary to put a large nose down input in to regain control of the axis before pitching nose up to (hopefully) rotate the aircraft before running out of runway!
Using the axis calibration of FSUIPC it is apparent that the steering tiller axis mixes rudder and elevator inputs during its range.
Anyone else had a similar experience?Andy
-
12-22-2009, 09:45 PM #2
- Join Date
- Jan 2007
- Posts
- 496
Re: FSUIPC Steering Tiller
There's really no way possible for that to occur. It is just another "rudder" calibration, nothing more, nothing less. It sounds like you have something else also assigned to that axis, or else some electrical crossover.
Try using FSUIPC's axis logging to see what is going on.
Regards
Pete
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
ADW thanked for this post
-
12-23-2009, 03:48 PM #3
- Join Date
- Sep 2007
- Location
- UK
- Posts
- 31
Re: FSUIPC Steering Tiller
Hi Pete
I used the axis logging function and operated the elevator and then the steering tiller before closing the log. It showed that the same axis (elevator) was operating for both inputs. I then used the FSUIPC axis assignment tab and consistantly operated the elevators to find that two axis letters were being detected for the elevator movement. But only one of these was assigned to the elevator. This was also the case for the steering tiller input. Four different axis letters for two distinct inputs.
I deleted all the axis assignments and set them up again. Then deleted the extra axis letters in the FSUIPC INI file. This seems to have stopped the problem.
I am not clear why the elevator and steering tiller inputs were each were each attracting two (different) axis letters. The aileron axis is served by the same axis card and was unaffected.
Thanks for the help Peter. What would we all do without you.
Andy
Similar Threads
-
First Officer Steering Tiller
By ian@737ng.co.uk in forum Cockpit Parts and Motion PlatformsReplies: 0Last Post: 12-04-2009, 03:11 AM -
737NG Steering Tiller
By ian@737ng.co.uk in forum Cockpit Parts and Motion PlatformsReplies: 15Last Post: 11-26-2009, 08:48 AM -
Steering tiller
By Philb737 in forum FS2Phidget UsersReplies: 22Last Post: 05-16-2009, 01:25 PM -
737 Steering Tiller (again)
By ian@737ng.co.uk in forum General Builder Questions All Aircraft TypesReplies: 1Last Post: 05-19-2008, 02:36 AM -
B737 Steering tiller
By Westozy in forum My Cockpit UpdateReplies: 15Last Post: 07-11-2007, 11:51 AM
Sexy Womans in your town for night
Run-Time Check # 0 - The value of...