Sliding pots and flaps

[mach7]

Hello;

I posted this same thread on a different sub-forum....I think it probably belongs here...sorry;

I am trying to set up my flaps using a 60 mm sliding potentiometer (RS6011Y50K), which is attatched to
the 'Bodnar' interface board using the FSUIPC utililty. I have arrived at some success, but even after
reviewing the attached FSUIPC documentation I am still having problems with setting up the detents.

I desire 5 flap settings of 0, 18, 24,30 and 33 degrees.

I have sucessfully set all 4 engines up and the lift spoiler system using the same pots and connections...
is just the flaps I am having trouble with.

My next question is.....can the flaps be set up using sliding pots (?)

- Jim

[caKus]

Hi Jim,

According to me, there is no reason why you cann't do it.

In FSUICP go to Axis Assignment tab, when you move the pot, check the in / out values must vary between -16384 and 16383 else there is a problem with the pot or the connexion to BU card.
- type of action : Send to FS as normal axis,
- Chose : Axis flap Set

Set delta to 1. Verify that the pot is not assign to a command in FS option command.

Regards.

Patrick.

[mach7]

Thanks Patrick;

I will give that a try

- Jim