Results 1 to 2 of 2

Thread: Cooling

  1. 02-12-2010, 05:28 PM #1
    flatlandpilot
    flatlandpilot is offline
    150+ Forum Groupie
    Builder Of The Month / Point Value: 100
    Total Awards: 1
    Total Points: 100
    flatlandpilot's Avatar
    Join Date
    May 2009
    Location
    Netherlands, Zwolle
    Posts
    150
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Cooling

    I had never used a coolant before,
    when the bit became too hot, I adjusted the speed down.
    until tonight, tonight I experimented with coolants.

    WD40, lamp oil and spiritus all work great.

    Do you use a coolant with acrylic ?
    When once you have tasted flight,
    you will forever walk the earth with your eyes turned skyward
    Reply With Quote Reply With Quote
  2. 02-16-2010, 07:38 PM #2
    Westozy
    Westozy is offline
    MyCockpit Support Staff
    Builder Of The Month / Point Value: 100
    Total Awards: 1
    Total Points: 100



    Westozy's Avatar
    Join Date
    Nov 2005
    Location
    Perth, Western Australia
    Posts
    1,412
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Cooling

    CRC, WD40 and spray lubricants are fine for assisting cooling on acrylics although it gets a bit messy. If you have a compressor, build a nozzle to aim at the tool with a valve for air control. Compressed air is a good coolant and it also clears the swarf away to be able to see what you're doing better! If the material is sticking to the tool it's time to slow down on feeds and speeds and it also maybe time to replace the tool as blunt tools overheat quickly. Generally I stick to around 8000-10,000RPM and feeds of 250/300mm per minute. I've cut quite a bit of 10mm clear acryilic using 3mm pass depths with a 3mm endmill, these speeds work quite well without cooling aids.

    Cheers, Gwyn
    Last edited by Westozy; 02-16-2010 at 07:40 PM.

    737NG using Prosim737, Immersive Calibration Pro, Aerosim Solutions motorized TQ & cockpit hardware, CP Flight MCP & FDS SYS1X, SYS2X & SYS4X, FDS PRO FMCs, AFDS units & Glarewings, Matrix Orbital ELEC display, Pokeys Landing & Cruise alt display, Buttkicker Gamers, 3 x BenqMW811ST projectors with a Matrox Th2Go
    http://www.aerosimsolutions.com.au
    Supporter of MyCockpit.org, please join me in donating!!!
    Reply With Quote Reply With Quote
  3. Post Thanks / Like - 1 Thanks, 0 Likes, 0 Dislikes
    Thanks fweinrebe thanked for this post
« Previous Thread | Next Thread »

Similar Threads

  1. Cockpit cooling fan?
    By John Countryman in forum PM General Q & A
    Replies: 0
    Last Post: 01-14-2006, 01:56 PM