No slats/flaps configuration possible in FMGS_config

[Fabiano2012]

hi guys,

i am using skalarki hardware and jeehell 52.0
inside profiler 5 everything works fine, in the i/O testing i get indications (changing numbers) of slat and flap-lever,
server is the fsx computer and this is inserted there, the correct hardware-selection (year) is chosen.
but back in jeehell there is no movement indication in the fmgs_config when i want to configure the levers (profiler is running).

do you have any idea how to solve the situation ?

cheers, Fabiano

[romeow]

Try to do this

Start FSX
Start Profiler (Stop Mode)

Start FMGS starten (Server und Client)
Profiler > Run
Shut FMGS Server
Start FMGS_config.exe
Configure the levers

Hope it will work!
Ciao, René

[Fabiano2012]

thanks rené,

i tried a few times and got the followings errors while working your list (picture below).
do you mean to close the fmgs_server (where all parts are shown which are connected or disconnected) or the wide_fmgs_server ?
if i do not start fmgs (jeehell) i can open the sidestick/thr/slats/flaps configuration without an error.

cheers, fabiano

[romeow]

I mean to close the starter.exe linked to starter.ini which starts with

[Starter]
FMGS_Server=yes

But I have to admit that I configured only my / Skalarki's TQ. With my proceeding I was finally successful - after a while!!

cheers, René

[Fabiano2012]

probleme is solved ... thanks.

for all of you, who are interested, how to do :
first go to skalarki profiler and enter all data you have to enter. than got to "edit profile" and look for e.g. lower pedestral and search the inputs and e.g. flaps and speedbrake. define the range and save. go to jeehell and there to the fmgs-config, configure the ranges again there. don´t forget to play with error-value in % and everything should work