Results 1 to 3 of 3
  1. #1
    150+ Forum Groupie skino's Avatar
    Join Date
    Nov 2008
    Location
    germany
    Posts
    297
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Question Arduino + 4x MAX 7219 + 7-Segment

    I want to build the displays of my MCP with Arduino Mega and the MAX7219 shift registers. Each shift register controls a six-digit seven-segment display with common cathode.

    Seeking a Arduino sketch that reads the values from the serial port and outputs to the respective seven-segment displays. Unfortunately I have not found on the various websites Arduino, this helps me. I dont want to use a system like MobiFlight.

  2. #2
    25+ Posting Member



    Join Date
    Jan 2013
    Location
    EVCA
    Posts
    62
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Arduino + 4x MAX 7219 + 7-Segment

    Hi,

    Check out my software: http://737ng.info/post/73

    I'm using it with my MCP to control 3 daisy chained MAX7219.
    Building 737NG cockpit and developing Arduino router software. My blog: http://737ng.info

  3. #3
    150+ Forum Groupie skino's Avatar
    Join Date
    Nov 2008
    Location
    germany
    Posts
    297
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Arduino + 4x MAX 7219 + 7-Segment

    Thank you for your post but I'm done with both the software and the hardware to 90%.