Problem in starting Skalarki Profiler in Jeehell, help needed

[spaceweather]

.Hello Freaks,
i know it might be bit offtopic, but i dońt know another community for that.
I redesigned my Homecockpit, using now p&p Hardware in a mix with IO Boards, but all is based on Skalarki systems.
So i cannot run the p&p Profile at all that comes with the newest 5.1 Profiler, i had to change some IOs of that p&p Profile, to Drive my overhead and FCU/MIP.

Now after starting the Profiler the following Error Comes up:
“Error occured during Running Profile. Group “ does Not exist.“

Where can i find the “ ? Its Hard to find it in the xml File of the Profile, isnt it?

Hope you know what i mean and someone can help.

Regards
Andy

[spaceweather]

Additional i can say that the same error occured by using the original Never changed „JlfmgsPandP“ Profile, that comes with the Profiler 5.1

[SSO]

Hi,

I had issues with upgrading to 5.1 as well. Do you have your previous profile?
I ended up adapting that because the new caused issues in many ways - the dial on the EFIS for baro (was working opposite with the new).
I had to correct two lines in my old relating to the Clock date then it works.

/Stephen

[spaceweather]

Solved now i think. Was a major bug in Profiler, thanks to Marcin for his online help

[Fabiano2012]

Solved now i think. Was a major bug in Profiler, thanks to Marcin for his online help

Hi Andy, is it a "major" bug to be known by everyone, or just within your sim ? Thanks