F22Phidget and Prepar3D

[Peter Nielsen]

Hi,
I have recently started using Prepar3D and most seem to work, but each time i launch FS2phidget i get an overflow error code 9 and it closes down, any one has any experience getting it to work with Prepar3D? is there any setting i need to change in the config files?

Tks
Peter

[gokhotit]

I worked with Alan on this a while back. I am running version 4.3.82 which works flawlessly with P3D. All you need is the latest FSUIPC and you are good.

[Peter Nielsen]

Tks for the hint, where does one find 4.3.82?? the last version on the download section is 4.3.66? and the problem is that i had huge problems with 4.3.66 as far as the flap detens was concered in FSX and roled back to much earlier version which works fine for me on FSX..
Peter

[gokhotit]

I dont know if the flaps issue will be resolved, as I use a GF-TQ6 for my flaps.

[Peter Nielsen]

I dont know if the flaps issue will be resolved, as I use a GF-TQ6 for my flaps.

Hehe ok you are lucky.. but where does one find the version you refer to 4.3.82?? and which version of Phidget Drivers are you using for this version?
Tks
Peter

[gokhotit]

sent you a pm

[KenK]

Hi all:

I am thinking of updating to P3d because of the improvements so far. I think they are on v1.3 already.
I like the fact that the displays actually stay locked. plus a lot of other improvements.

Right now I am using FS2phidgets w/w7-64 can anyone get me a v4.3.82 ??

Regards to all
KenK

[bagarie]

HI Guys,

also me need the new Fs2Ph version to work with P3D. Anybody have the v.4.3.82?

Thanks and REgards
Arnaldo

[CocnutAir]

Look in Downloads: Fs2Phidget. Below has been there since 12-12-2012.

FS2Phidget Update - 4.3.86 : Update to existing version 4 installs. Unzip fs2phidget.exe and install in current fs2phidget direct ... [more] (444.6 KB)

[KenK]

OOps forgot to look there . Thanks Alan !!