Results 1 to 3 of 3
Thread: Question for all Bus drivers
-
06-15-2007, 06:10 AM #1
- Join Date
- Apr 2007
- Location
- Sydney
- Posts
- 51
Question for all Bus drivers
This may be a "blonde" question but...
On the 737 the throttles moves with the auto throttles engaged. When you hit the disengage button they stop moving and remain in the same place where they were. ie at the same thrust.
Well on the Airbus the throttles are placed in the auto thrust detent and do not move.
Now the question is this.
When you hit the red button on the throttle handles to disengage the auto thrust, does the power ramp up to full because thats where the throttles are?
I hope this question makes some sense.
I have the same problem with a std logitech joystick.
When you disengage the autothrottles when flying the std fs9 737 and touch the throttles FS instantly changes the trust setting.
This makes approaches quite interesting.
So how does the real airbus handle this?
Thanks everyone.
-
06-15-2007, 07:04 AM #2
Well, Im not a pilot but also a bus builder and if I remember it right it goes
the following way...
Normally the autothrust is not disconnected by pressing the disconnect button
but by reaching the idle detent with the throttles, thus no surge is possible
If the crew decide to use the disconnect button then they need to be carefull
and they need to bring the thrust levers back until the small ball sign on the engine page is lined up with the engine setting. Then they can press the disconnect button and no surge happens. If they would leave the thrust levers
in the climb detent and press the button I think the engines would spool up to reach the climb thrust setting.
Greetz Peter Depoortere
PS I hope Roberto concurs with this....
-
06-15-2007, 09:55 PM #3
If you disconnect them in the CL detent with the Red Instinctive Disconnect Pushbuttons it enters a mode Called Thrust Lock... SO it remains in the last thrust setting that was at the time of the disconnect... Now to disconect it so that you donīt ha ve a surge you brinc them back to the TLA setting that is Thrust Lever Angle which basically a dot on the Engine Indication and you push the red switches or you Idle it and press the red switches which is not always teh best case...
Regards,
Roberto
Similar Threads
-
Quick question for 727 drivers
By orwell84 in forum Where to Start Building a Home CockpitReplies: 14Last Post: 02-17-2009, 01:40 PM -
Airbus Drivers!!
By mounty in forum Cockpit Parts and Motion PlatformsReplies: 8Last Post: 02-11-2009, 07:37 PM -
A question for "Bus Drivers"
By mpl330 in forum General Builder Questions All Aircraft TypesReplies: 2Last Post: 01-31-2008, 06:56 PM -
Hey Bus Drivers! Look at this!
By AndyT in forum I/O Interfacing Hardware and SoftwareReplies: 3Last Post: 07-29-2007, 06:23 PM -
voodoo2 drivers
By Michael Drobbe in forum PM General Q & AReplies: 0Last Post: 02-12-2006, 04:48 AM
Prettys Womans from your city for night
A320 Sound Files Missing