Results 1 to 5 of 5
Thread: SIOC Locking up
-
09-13-2016, 04:04 PM #1
- Join Date
- Aug 2008
- Location
- Dallas, Texas
- Posts
- 192
SIOC Locking up
A few days ago I started up my cockpit computers, started Prosim737 and SIOC but none of my switches etc were working. I tried reloading my script and SIOC locked up. All my Devices are listed in the Device window. SIOC Monitor and IOCPConsole both will open but nothing works. I tried reloading my script and SIOC locked up. The log window said "RELOADING SIOC". Exit would not work so I had to use the Task Manager to close it. Restarting my computer didn't help. I finally uninstalled and reinstalled SIOC but that didn't work. I uninstalled my AVAST Antivirus thinging maybe it was the culprit. I finally contacted Open Cockpits Support and they said there could be an IP Address conflict with another program. All the information I googled dealt with other computers on the network, not with programs. Other than a complete Windows, etc. reinstall (nightmare) I don't know what to try next. Has anyone else had this happen before?
Jerry
-
09-13-2016, 09:06 PM #2
- Join Date
- Jan 2007
- Location
- NEW ZEALAND
- Posts
- 908
Re: SIOC Locking up
Jerry,
In sioc you can change the port number used, maybe you could try another number.
Les
-
09-14-2016, 03:49 AM #3
- Join Date
- Dec 2010
- Location
- Netherlands
- Posts
- 20
Re: SIOC Locking up
Have you tried to restore your system to an earlier reset point? Because something must have changed since the last time all worked well. Windows update perhaps?
Jan
-
09-14-2016, 12:33 PM #4
- Join Date
- Aug 2008
- Location
- Dallas, Texas
- Posts
- 192
-
09-17-2016, 12:26 PM #5
- Join Date
- Aug 2008
- Location
- Dallas, Texas
- Posts
- 192
Re: SIOC Locking up
It appears that I fixed my SIOC not working problem. I think it was a hardware issue. The USB connector on one of my Expansion Cards was loose. I wiggled it a little and SIOC started working. Guess I need to replace it. If that wasn't the problem then it was a coincidence and something fixed itself.
I think I may have had a misconception about Prosim. Do I just need to use the definition file for Prosim, change the inputs/outputs and Prosim handles all the calculations? Maybe that's why I'm having some issues. I thought I needed to tell the switches, etc. what to do in my script.
Jerry
Pretty Girls from your city for night
Generic Analog Gauges