Results 1 to 8 of 8

Thread: PC power Supply

  1. #1
    300+ Forum Addict BlackWidow's Avatar
    Join Date
    Dec 2006
    Location
    Tehacahpi CA, USA
    Posts
    437
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    PC power Supply

    Cant find a exact solution to my problem in the search function I have two 350wat power supplies form old PC. I pluged them both in (they were working when pulled form PCs) but I get nothing from them Is there a trick to getting them to turn on when not plugged into a MB. Thanks

    Mike

  2. #2
    300+ Forum Addict BlackWidow's Avatar
    Join Date
    Dec 2006
    Location
    Tehacahpi CA, USA
    Posts
    437
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    WHOO HOOO got it find it on a car stereo enthusists website. For anyone else who may not know on an ATX power supply simply jumper the green wire with any ground and bingo you have power.

  3. #3
    150+ Forum Groupie andarlite's Avatar
    Join Date
    May 2007
    Location
    Mississauga, Ontario, Canada
    Posts
    260
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Look on the 20 pin molex connector.... there's a green wire (Pin 14)... signal name is "P/S On". You need to connect that to GND (any of the black wires).... then turn the power supply on. Should fire up.

    Regards,
    Henry

  4. #4
    300+ Forum Addict BlackWidow's Avatar
    Join Date
    Dec 2006
    Location
    Tehacahpi CA, USA
    Posts
    437
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thanks for the reply I think i found it as you were writing thanks again.

    Mike

  5. #5
    150+ Forum Groupie ak49er's Avatar
    Join Date
    Jan 2007
    Location
    Big Lake, Alaska
    Posts
    281
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    May be Different

    This is very useful, I thought that you had to add a 10 ohm resistor somewhere? OR is this for a different type of PS?

  6. #6
    300+ Forum Addict BlackWidow's Avatar
    Join Date
    Dec 2006
    Location
    Tehacahpi CA, USA
    Posts
    437
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Yes i did read about that but it turns out that some power supply's will not turn on with out a load. That is when you would use the 10ohm resistor to put it under load. At least thats what i gathered from the article i read. I actually was able to power it up and hooked up a 12 volt map light that i had laying around it woked perfect. I plan on using 12 volt bulbs for backlighting and i can use the same power supply for LEDs sweeet and it turns out I have 2 350W and 1 300W power supply's just laying around.

  7. #7
    Tim
    Guest
    This setup works very well for me. I use it to power the Photon interface boards.

    http://web2.murraystate.edu/andy.bat...owerSupply.htm

  8. #8
    300+ Forum Addict BlackWidow's Avatar
    Join Date
    Dec 2006
    Location
    Tehacahpi CA, USA
    Posts
    437
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thanks for the link thats some good info. I think its a great idea to use the power supply's because all of us computer nerds probably have some just laying around dying to be used.

Similar Threads

  1. PC power supply to power Phidgets LED 64
    By drum4no1 in forum General Builder Questions All Aircraft Types
    Replies: 1
    Last Post: 07-05-2010, 03:21 PM
  2. GPU / Power Supply Question
    By smendlik in forum Computer Hardware Setup
    Replies: 1
    Last Post: 10-28-2009, 08:20 PM
  3. 12V power supply
    By Jackpilot in forum General Builder Questions All Aircraft Types
    Replies: 4
    Last Post: 01-24-2009, 03:45 AM
  4. Main Power Supply
    By NNomad007 in forum General Builder Questions All Aircraft Types
    Replies: 18
    Last Post: 11-20-2008, 01:53 PM
  5. Power Supply
    By Tim in forum Cockpit Parts and Motion Platforms
    Replies: 1
    Last Post: 05-28-2007, 08:13 AM