Baron b58 simcockpit

[munjaki]

Hello

not much but i'm working on this cockpit about 1 year with 10 month pause, so actualy this is 2 months job.
Using wood and 3d printed parts , this is for X plane 10/11 and my plan is to use arduino and ARDsimX.

I make couple thing in 3d and thay are free on http://www.thingiverse.com
ADI KI -256 http://www.thingiverse.com/thing:1257130
Airvent http://www.thingiverse.com/thing:2296533
Flaps cap switch http://www.thingiverse.com/thing:2300674

Right now i'm working on 3 things

Beechcraft Yoke
Gear lever
An Bechcraft start switch

Some pictures


I need blueprinrts for Yoke , than is 50 % done, but all 3 projection picture can help me to make things easy to do.
All Switch is get plast cap on (3d printed aswell)

[Guiaguia]

Hi, munjaki, compliment for your work.
I will make the home cockpit of the B58 and , for now, I'm searching on internet tutorials and material for my goal.
I would for firts cut the mainpanel (I will cut the wood with laser) and the switch panel.
I see in your photo that you realized the writes (or serigraph) of the lower panel, can you tell me how you have make it? what font have used? you can give me the files of the serigraph?
Thanks and compliment.
Regards

[munjaki]

That is plexiglas painted and laser cutted + laser printed lethers.. ordered from Poland by some guy on Facebook, it cost me about 150-200 euro 4 low panels, than cuts for GPS 2 pcs and for radio 2 pcs, 2 more equpemnt faceses... If you want i can make contact on FB.

[munjaki]

I have somewhere files.. on hard disk...have to find tham