Results 1 to 5 of 5
  1. #1
    25+ Posting Member pylet's Avatar
    Join Date
    Dec 2006
    Location
    North Pole, Alaska
    Posts
    74
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Soldering EL-Sheets

    Got a question, I don't understand how to attach a wire to the el-sheets without destroying them even with a low power 20w soldering iron? And the 1/4" wide sticky backed copper tape, I have no clue what that is for. How am I to attach the copper tape to the el-sheet so that wires can be soldered onto the tape? I've ruined half a sheet trying to figure out how to solder wires to it. Good thing I bought two.

    Any help would be greatly appreciated.
    Lyle Kirgan
    B737NG SSTD Owner

  2. #2
    Executive Vice President, MyCockpit


    Matt Olieman's Avatar
    Join Date
    Oct 2005
    Location
    Ocala, FL USA
    Posts
    2,883
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Sheets I got came with clips/clamps (or whatever they call them) to attach to the EL-Sheets. Didn't know you can solder to them.

  3. #3
    25+ Posting Member pylet's Avatar
    Join Date
    Dec 2006
    Location
    North Pole, Alaska
    Posts
    74
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Finally got an e-mail back from the company along with some instructions that'll post here. My biggest mistake was that I was letting the copper tape "touch" the white line. As long as the tape does not touch that line it works fine. Thanks for the reply.
    Attached Files Attached Files
    Lyle Kirgan
    B737NG SSTD Owner

  4. #4
    1000+ Poster - Fantastic Contributor Bob Reed's Avatar
    Join Date
    Oct 2005
    Location
    Holley, New York U.S.A.
    Posts
    1,776
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Also keep in mind you can not let the sheet touch any metal including switches or you will get zapped! Be sure to leave space!
    Bob Reed

  5. #5
    New Member
    Join Date
    Oct 2011
    Location
    Colorado
    Posts
    1
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: Soldering EL-Sheets

    Can you repost the attachment?

    Quote Originally Posted by pylet View Post
    Finally got an e-mail back from the company along with some instructions that'll post here. My biggest mistake was that I was letting the copper tape "touch" the white line. As long as the tape does not touch that line it works fine. Thanks for the reply.

Similar Threads

  1. Questiong about soldering / OpenCockpits Master Card help needed
    By pi1er in forum General Builder Questions All Aircraft Types
    Replies: 8
    Last Post: 11-25-2009, 05:38 PM
  2. Wireing and Soldering
    By Peter Nielsen in forum I/O Interfacing Hardware and Software
    Replies: 2
    Last Post: 11-01-2007, 08:56 AM
  3. My MCP and EL Sheets
    By pylet in forum My Cockpit Update
    Replies: 0
    Last Post: 03-10-2007, 10:41 PM