Results 1 to 4 of 4

Thread: TRIM WHEELS

  1. 08-25-2014, 11:12 AM #1
    simonb737
    simonb737 is offline
    New Member
    Join Date
    Aug 2014
    Location
    Germany
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    TRIM WHEELS

    Hello ,

    which is the correct FSUIPC offset that reads the value of the TRIM WHEEL POSITION?

    Thank you in advance
    Reply With Quote Reply With Quote
  2. 08-25-2014, 01:22 PM #2
    Danilo
    Danilo is offline
    Our new friend needs to reach 10 posts to get to the next flight level


    Danilo's Avatar
    Join Date
    May 2011
    Location
    Ljubljana, Slovenia
    Posts
    9
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: TRIM WHEELS

    In my King Air B200 cockpit I have a motorized trim wheel and I use the offset 0BC0 for both, setting (in manual mode) and reading (in AP mode) of the elevator trim value. Since the trim wheel directly indicates and sets the position of the elevator trim (or stabilizer in B737) I suppose there is no need of using offset 0BC2 just for elevator trim indication.

    Regards,
    Danilo
    Reply With Quote Reply With Quote
  3. 08-26-2014, 07:14 AM #3
    simonb737
    simonb737 is offline
    New Member
    Join Date
    Aug 2014
    Location
    Germany
    Posts
    3
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: TRIM WHEELS

    Hello Danilo,

    can you tell me whats wrong with these settings? Fs2Phidget still doesnt show me the trim wheel value but only 0. And whenever i type in an offset, it shows INTERN in the offsett column.

    Thank you
    FSPHIDGETS PROBLEM.jpg
    Reply With Quote Reply With Quote
  4. 08-26-2014, 07:48 AM #4
    Danilo
    Danilo is offline
    Our new friend needs to reach 10 posts to get to the next flight level


    Danilo's Avatar
    Join Date
    May 2011
    Location
    Ljubljana, Slovenia
    Posts
    9
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: TRIM WHEELS

    Sorry, but I am not familiar with the software you are using. As far as I can see, the settings are correct.
    What aircraft are you using in FSX? Does it work with default aircrafts? What are the results when using offsets 0BC2 or 2EA0? Do you have problem only with the elevator trim value or also with other offsets?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »