A320 FMGS B38

[jeehell]

Hi all,

the latest version is available here :
http://www.jeehell.org/A320FMGS_B38.9.exe

Best regards,
JL

[romeow]

Hi JL,

first of all thanks for the new version!

As I faced different problems with version 37 I downgraded again to 36.3 weeks ago. This version (with SIOC 4.6) runs without any problems on my system. I had no time and no fancy to experience with 37.

Actually I like to try your new version 38. Is it reasonable (or even indispensable) to install the latest SIOC version as well? And if so would you suggest to rewrite the SIOC script with your SIOC_CREATOR or will a new compilation of the txt file into an ssi file suffice?

Thanks for advice!
Regards
René

[OmniAtlas]

Hi JL,

Do you know what it would take to make your software run with XPlane?

I am using XPUIPC, and XConnect which converts values from FSUIPC, but after starting your software I cannot even start the batteries.

Is there some additional programming which would need to be done?

I've grown quite impressed with XPlane and would like to leave FSX/P3D behind -- here is a recent video I took: https://www.youtube.com/watch?v=JWDC9H_jzzw

[turbovela]

JL,

Do you recommend a fresh install for B38 or can we just use the updater?

Thanks,

Jose

[OmniAtlas]

Hi JL -- thank you for the update.

I also get the FLAC1+2 errors (autopilot also automatically disconnects), and abberations on ND with terrain EGWS turned on (try airport YBCG, YBBN).

Regards.

[jeehell]

Hi all,

Try this new version:
http://www.jeehell.org/A320FMGS_B38.1.exe


I will not add xplane support because of no available A320 flight model that can be used, and the time required to add full support.

Some EGPWS issues may come from graphics cards/drivers.

JL

[manuelthomi]

Hi

I don't get any FAC fault anymore with the new version. Thank you for fixing that.

But with this new version I can't move the ailerons on ground, e.g. for the flight controls check. The ailerons are only moving a little bit on the f/ctl page of the ecam. In flight everythings works fine.

Best regards
Manuel

[tcane]

Hi JH,

today i made the update of your new Version! Big thanks for your hard work! Installed all as Admin.

I got also the ELAC2 fail on the FLT CTL. Can not turn on or off.

The issue with the crashing P3D and not connection/connection of the clients in your Server still be there.
What i have finde out. When i start P3D, FMGS and SIOC as Admin, P3D doesn´t crash, but with the small issue of the displayed connection. Like in this Video.
When i forget to start SIOC or start it without admin rights, P3D crashes but the clients displayed as connected in your Server. In the next time, make also a video of the crash.

King regards
Florian

[romeow]

Hi JL or all others,

again my two questions. A simple yes or no suffices!

1) Do I need to install SIOC 5.0 for38.1.?
2) Do I have to reconfigure then with SIOC_Creator?

Thanks!
René

[tcane]

Hi Renè,

1) You does´t need SIOC 5.0. An older Version of SIOC also works.
2) Since the last 3 big Version Updates i reconfigure the Jeeheel.txt every time with the SIOC-Creator.

Cheers
Florian