Results 1 to 8 of 8

Thread: TREV Nice Pics

  1. #1
    Executive Vice President, MyCockpit


    Matt Olieman's Avatar
    Join Date
    Oct 2005
    Location
    Ocala, FL USA
    Posts
    2,883
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Thumbs up TREV Nice Pics

    Nice pics in the Gallery Trevor.... Getting there fast..... When's the maiden voyage???

  2. #2
    2000+ Poster - Never Leaves the Sim Trevor Hale's Avatar
    Join Date
    Nov 2005
    Location
    Ontario, Canada
    Posts
    2,221
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    ROFL! Soon I hope.

    I need to order 3 flat panel monitors to go behind the MIP. This is somewhat holding me back. I need to finish the walls and such, but don't want to do to much more until I get my instruments cut and the bezels installed. I am trying to decide if I wan't 3 X 19" or 2 X 17" and a 19".

    The 14" CRT's I used in my Airbus just won't be as good in this new baby.

    Any suggestions. What seems to work best?
    ________________________
    Trevor Hale

  3. #3
    MyCockpit Support Staff


    Westozy's Avatar
    Join Date
    Nov 2005
    Location
    Perth, Western Australia
    Posts
    1,412
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hi Trevor,

    My Nav and Att displays are 145mm square on the outside pair of 17" CRT monitors, this is as big as they can be and are plenty clear enough. I currently have a 17" for the 180mm square EICAS centre display, If the centre monitor was a 19" it would be able to display the standby instruments too. I plan to replace the CRTs with LCDs eventually and reposition the stby gauges in the pnl cfg to try this later - something to consider...

    Gwyn

    737NG using Prosim737, Immersive Calibration Pro, Aerosim Solutions motorized TQ & cockpit hardware, CP Flight MCP & FDS SYS1X, SYS2X & SYS4X, FDS PRO FMCs, AFDS units & Glarewings, Matrix Orbital ELEC display, Pokeys Landing & Cruise alt display, Buttkicker Gamers, 3 x BenqMW811ST projectors with a Matrox Th2Go
    http://www.aerosimsolutions.com.au
    Supporter of MyCockpit.org, please join me in donating!!!

  4. #4
    MyCockpit Support Staff dodiano's Avatar
    Join Date
    Oct 2005
    Location
    El Salvador
    Posts
    929
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Airbus

    Horrible Horrible Sim ( EXTREMELLY JEALOUS AND ENVIOUS PERSON) !! LOL!!

    Dude that Rocks I always thought of a Falcon sim since I flew that addon for FS2002 Falcon 50 which I really loved amazing ADDON! AND FREE EVEN BETTER LOL!! What you going to use to fill up those Screens?? Magenta Regional jet??

    Regards,

    Roberto

  5. #5
    2000+ Poster - Never Leaves the Sim Trevor Hale's Avatar
    Join Date
    Nov 2005
    Location
    Ontario, Canada
    Posts
    2,221
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    I bought Magenta Boeing, I am working on the Falcon 900Ex model, which uses an all glass cockpit. I havn't sent my request to Thomas yet to get a little guidance on the Overhead logic, but I happen to have all the manuals explaining how it all works. Left and right will be PFD and ND and the middle will be Standby and EICAS Like in the 737. I was thinking of using Lego Blocks for my annunciator set. I will edit the PM .ini files to see if I can get the performance as close to the real thing as possible.

    I wanted the full FMS capability so I went Boeing instead of the RJ set.

    I am crossing my fingers, I figure sheesh, if it won't work right then I will have a 3 engine 737 that looks like a Dassault falcon 900...

    Thanks for your comments,

    Trev
    ________________________
    Trevor Hale

  6. #6
    1000+ Poster - Fantastic Contributor Bob Reed's Avatar
    Join Date
    Oct 2005
    Location
    Holley, New York U.S.A.
    Posts
    1,776
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    I know that no one seems to get his but.... The RJ stuff works with the Boeing CDU and MCP. And when you buy it you can get Enrico to allow you to upgrade to the full RJ stuff when it comes out.
    Bob Reed

  7. #7
    2000+ Poster - Never Leaves the Sim Trevor Hale's Avatar
    Join Date
    Nov 2005
    Location
    Ontario, Canada
    Posts
    2,221
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    DOH!

    Ah well, Like I said before, If it doesn't work the way I want it, it will be one funny looking 737

    By the way Bob, did you ever get my Private message regarding your FMS measurements?
    ________________________
    Trevor Hale

  8. #8
    1000+ Poster - Fantastic Contributor Bob Reed's Avatar
    Join Date
    Oct 2005
    Location
    Holley, New York U.S.A.
    Posts
    1,776
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Yes and I replied!!
    Bob Reed

Similar Threads

  1. nice radio!!
    By Jackpilot in forum General Builder Questions All Aircraft Types
    Replies: 7
    Last Post: 08-07-2009, 08:31 AM
  2. Nice unit...
    By Jackpilot in forum General Builder Questions All Aircraft Types
    Replies: 2
    Last Post: 09-08-2008, 12:34 PM
  3. Nice MIP
    By Jackpilot in forum General Builder Questions All Aircraft Types
    Replies: 0
    Last Post: 02-29-2008, 11:39 AM
  4. A couple of nice pics
    By 737NUT in forum My Cockpit Update
    Replies: 3
    Last Post: 12-24-2007, 04:17 AM
  5. Nice 727 Sim
    By QF6228 in forum General Builder Questions All Aircraft Types
    Replies: 1
    Last Post: 08-17-2007, 09:20 AM