Results 1 to 3 of 3
  1. #1
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Aug 2008
    Location
    Hamburg, Germany
    Posts
    7
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    4,3" wide LCD screens

    Hi!

    Has anyone an idea how to interface a TFT screen with VGA? I have found at Reichelt Elektronik here in Germany a 4,3" 16:9 LCD screen that can be used to make a GNS430 unit also very cheap cost only around 50,-Eur.

    I have checked the usual suspects earthlcd and avionicslcd but they have only 5,6 and 3,5 displays. i have one 10,2" LCD kit from earthLCD with which i intended to make a G1000 but i am not so sure if i can use the VGA hardware to interface those smaller screens.

    Cheers!

    Jan

  2. #2
    150+ Forum Groupie


    jonesthesoftware's Avatar
    Join Date
    Jul 2009
    Location
    aberdare, south wales UK
    Posts
    261
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: 4,3" wide LCD screens

    Hi Jan

    is this the model you refer to
    EA EDIP-TFT43ATP :: TFT-Grafikdisplay 10,9cm 480x272 mit Intelligenz
    if so it has some unusual interfaces I2C, RS232, and SPI bus,can't see how you connect this to VGA.
    You can get a 5inch here which will connect direct to your PC VGA output that's 5 inch diagonal which is 4x3 inches I think.
    Accelevision LCDP5VGA 5 Inch LCD Universal Monitor with VGA Input
    The size of screen has nothing to do with the interface. VGA simply refers to the pixel density and the electrical hardware used, so as long as what you buy says VGa then it's OK to connect to your graphics card.

    But what about the usual Playstation PS1 screens which everyone uses for their FMCs, which are approx 4 inches by 3 inches and can easily be interfaced to your PC using a VGA to RCA adaptor, all from ebay and cheap!
    regards
    geoff

  3. #3
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Aug 2008
    Location
    Hamburg, Germany
    Posts
    7
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: 4,3" wide LCD screens

    Hi Geoff,

    Thanks for the reply! Actually I was looking at this one:

    TFT-Display 10,9cm (4,3) ohne Touch Panel, 480x272 WQVGA

    The beauty to that is that to my calculations the GNS430 Unit screen almost exactly matches this size. The problem i have is how to interface it, I guess I need a VGA controller board that can do the job. i have already inquired with Ginsbury who seem to be the guys who can supply that. Anothe solution would come from Car entertainment solutions where they offer these displays with normal "TV in" SVIDEO connections, i guess I could easily use a VGA adaptor here as well - however i would prefer the VGA or even better USB monitor connection.


    Cheers,

    Jan