Results 1 to 3 of 3

Thread: New Machine!!

  1. #1
    Have CNC-----will build.
    Join Date
    Oct 2009
    Location
    Leesburg, Florida
    Posts
    201
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    New Machine!!

    Finished building my new CNC machine today. It will cut an area of about 24" on the 'x' and 11." on the 'y'. The 'z' will pass over a 2.75" piece of material. The materials used in construction are PVC, MDF, and HDPE. You will see in the pictures that I have used HDPE bushing on the main lower rails, and the Y axis rails. I got rid of the Dremel tool in favor of the Proxxon unit. The Proxxon unit is extremely quiet and has no brushes to wear out. The cost of this unit for just the frame, rods, threaded rod and other materials is under $150.00. This is without any electronics at all. You can see it is dirty, I have done some tests with it. It cuts as near perfect a circle as I could ask it to, close enough for government work. Any questions, just holler. I may think about building these for others, labor is the killer. It takes about 2 days to make one of these from the beginning to the end.

    Milt
    Attached Images Attached Images

  2. #2
    500+ This must be a daytime job



    Join Date
    Jan 2007
    Location
    NEW ZEALAND
    Posts
    899
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: New Machine!!

    Nice one Milt,
    Now the fun begins.

    Les

  3. #3
    150+ Forum Groupie riche543's Avatar
    Join Date
    May 2008
    Location
    Sydney Australia
    Posts
    248
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: New Machine!!

    Nice 1 !!!

Similar Threads

  1. New CNC Machine
    By mondo50m in forum CNC Discussion
    Replies: 7
    Last Post: 09-07-2010, 02:16 AM
  2. What do you think of this CNC machine?
    By twisted8 in forum CNC Discussion
    Replies: 5
    Last Post: 07-27-2010, 02:15 PM
  3. New CNC Machine
    By mondo50m in forum General Builder Questions All Aircraft Types
    Replies: 6
    Last Post: 04-13-2010, 08:13 PM
  4. Your CNC Machine..
    By riche543 in forum CNC Discussion
    Replies: 10
    Last Post: 02-26-2010, 04:45 PM
  5. Looking for CNC machine
    By AndyT in forum Westozy's Mechanical Engineering
    Replies: 36
    Last Post: 01-26-2009, 11:58 PM