Results 1 to 2 of 2
Thread: Setting reverse thrust
-
10-02-2008, 09:13 PM #1
Setting reverse thrust
Looking at my L1011 throttle quadrant, the reverse levers simply extend the movement of the linkage that goes to the engine controls. So with one pot for each throttle lever, I need to set a band where the pot value goes below a certain level, reverse thrust is entered and controlled proportionally. Well is there an easy way to do all of this? This question is for FS9, FSX, and X-plane9. Guess I may have to write my own software..
-
10-03-2008, 05:31 AM #2
- Join Date
- Jan 2007
- Posts
- 496
I don't know about X-Plane, but for FS if you have a registered FSUIPC installed you simply need to use the separate Throttle assignments (1-4) either in FS or in FSUIPC's axis assignments, then calibrate the reverse, idle zone and max in FSUIPC's calibrations tab for 4 throttles.
Regards
Pete
Similar Threads
-
Reverse Thrusters on FSX
By docmeister in forum General Microsoft Flight Simulator 10 (FSX)Replies: 5Last Post: 06-18-2009, 07:13 AM -
Throttle Pots and Reverse thrust
By ozziesim in forum Phidgets & Cockpit Simulator BuilderReplies: 7Last Post: 05-18-2008, 08:50 PM -
input reverse
By aviaparts in forum FS2Phidget UsersReplies: 1Last Post: 04-02-2008, 04:53 PM
Prettys Womans from your city for night
A320 Sound Files Missing