Problem Airbus radio panel

[mmakela]

Hello, I'm trying to configure my RMP panel with TCAS panel.
I have only capt side pedestal, except TCAS is in right hand side off course.
I do not get first digit "1" to radio segments. What offset controls
it? I guess it is an independent led that should write "1" all the time?
My output number is 68 for active side first digit.

I'm only trying to use following buttons for RMP :

VHF1 as com1
VHF2 as com2
VOR (standby nav line) as nav2
ILS (standby nav line) as nav1
ADF (standby nav line) as adf
In ACP panel I have two inputs for CALL Vhf1 and vhf2 and ON VOICE button.

TCAS is not working at all. Cannot see any digits. Also rotarys does not work.
I have inputs for this :
left side upper rotary input 138 and lower 136
right side upper rotary 131 and lower 133

I propably need some help. Problem is that button names / assemble are different in real
aircraft than FSX panel and those names in opencockpits manuals. Could be easier to use
real names of things?

Thanks,
Markus

[mmakela]

Ok, I got tcas now by pressing a
custom button. When I push it Tcas
digits come up but all digits in radio panel
disappears. So tcas is swapped. How
to get rid of this function and that digits
in tcas panel could stay all the time?
I just do not get the logic here. What
are libre offsetts? What offset controls
those first "1" digits in radio panel.
I try to use Brians setup with no luck.

[mmakela]

Ok, it works now as I wish, except I have no first "1" digit for active and standby
displays. Is there any way to config one particular segment to 1 via iocards.exe
program? I do not want to solder because it is difficult to take panel off and put it back.
I use those opencockpits pcb boards for those displays.

[mmakela]

Got it! A320 ready for take off after 3 years building