triplehead2go & Immersive display pro problem

[bindook]

i'm hoping some1 has a solution to this problem.

I'm trying to setup immersive display pro then run fsx WITHOUT having to change the display settings??

Basically what is happening is I need to set projector 1 to configure immersive, I get it setup to a flyable state. I save the configuration. But then to get fsx on all 3 screens I need to change the display settings to start up on projector 2 the display works e.g blended

Now when I restart w7 the blending has gone & needs re-aligning.... I have spoken to fly-elise & from that I think the cause is the desktop display is being changed.

My question is how can I get fsx to display in all 3 projectors if I start it in projector 1? or get immersive to display in all 3 if started In projector 2?


Thanks

Michael

[Miatanet]

Hi Michel

i guess you need to set up the 3 beamers or screens as one screen in windows, nvidia has a special setup for that if you are using nvidia, also the matrox driver should have this setting to make on 3x1 display...

or dis i get you wrong?

Best regards
Stefan

Another question from my site, I just board 2 equal beamers and using immersive display pro too, but i spend already about 4h to set up my beamers on my 180 degrees curved screen, but it messed up and i do not get this combiend. Do you have other tutorials availabel?

BR
Stefan

[OmniAtlas]

Have you tried the imme dive display pro auto configuration?

[bindook]

As always after I post a problem I resolve the issue

Problem was the matrox manager was still showing 3 x displays where it should have been 1 !!!

Stefan I used these tutorials; (I did mine manually)

https://www.youtube.com/watch?v=wKDDAZChghs

https://www.youtube.com/watch?v=yODUWFpY6io

https://www.youtube.com/watch?v=YAQd_I76d7A (this 1 is different software but same principle)


Michael

[bindook]

1 more

https://www.youtube.com/watch?v=o7H4kN6gWeg