Results 1 to 3 of 3
Thread: TQ simulatory issue
-
10-08-2009, 01:41 PM #1
- Join Date
- Feb 2008
- Location
- Italy
- Posts
- 70
TQ simulatory issue
Hi to all.
I've just bought a TQ Simulatory from a my friend. I changed the Fsbus interface with the Leo Bodnar interface to better use with Fsuipc. But I have a problem with the Thrust lever N2 potentiometer. It give not smooth value like the N1.
exemple: In Fsuipc calibration page, I see values change from -16383 to 0 suddenly with no intermediate values like the potentiometer for thrust N1.
Do you know how to disassembly the TQ in order to change the potentiometer?
Many thanks and sorry for my bad english.
Arnaldo Vacca
-
10-08-2009, 05:42 PM #2
Re: TQ simulatory issue
I shall watch this thread with interest as I need to do this too
Was it easy to remove fsbus and replace with the Leo card?
Cheers
Mike
-
10-09-2009, 02:18 AM #3
Re: TQ simulatory issue
mike,
it's not difficult if you have 16 pin IDC plug connecting the switches & pots to your control board. there's a wiring diagram on my website and if you need, i'll walk you thru it.
i've done it a couple of times for colleagues.
rgds ... ianMr. Ian. P. Sissons is hereby recognised as an Honorary Flight Sim Captain following his passing in February 2016. This is in recognition for his commitment to Flight Simulation.
www.mycockpit.org Featured Builder August 2008 www.737ng.co.uk
FS9/PROSIM737/CPFLIGHT/Lots of BU0836X's and a Beer Fridge
Similar Threads
-
Elevator issue
By Soufiane in forum JeeHell Ware Q&A and DiscussionsReplies: 3Last Post: 04-18-2010, 01:43 PM -
simulatory front and aft overhead for sale
By jeroen in forum Cockpit Parts and Motion PlatformsReplies: 4Last Post: 12-10-2008, 11:57 AM -
FSUIPC issue?
By DENNIS ORSAG in forum General Builder Questions All Aircraft TypesReplies: 4Last Post: 03-30-2008, 10:50 AM
Sexy Womans in your town for night
Run-Time Check # 0 - The value of...