Results 1 to 2 of 2
  1. 02-29-2012, 10:19 AM #1
    notgotaclue
    notgotaclue is offline
    300+ Forum Addict notgotaclue's Avatar
    Join Date
    Nov 2010
    Location
    Wales
    Posts
    348
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    How to connect a cockpitsonic usb flaps gauge

    ignore me, i got the answer
    Reply With Quote Reply With Quote
  2. 02-29-2012, 02:58 PM #2
    notgotaclue
    notgotaclue is offline
    300+ Forum Addict notgotaclue's Avatar
    Join Date
    Nov 2010
    Location
    Wales
    Posts
    348
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: How to connect a cockpitsonic usb flaps gauge

    Whilst I started this thread I might as well ask a proper question.
    I have connected the power supply and it all works hunky dory. In fact must easier to set up than I was imagining.
    Do I need a power supply to run the gauge as it works fine just plugged into a USB port? Is the power supply purely for the backlight and to give it a bit of extra juice?
    I want to cut down on "things" that are powered and red, black and yellow wires, as my sim is now beginning to look like one of those old fashioned telephone exchanges, except a lot less organised. I can live without the backlight if that is "all" the power supply is needed for.
    Allan.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »