More rotaries problems

[mr_mojo97]

Hi all, I've looked at quite a few posts/ threads but still can't figure this out. I've got a Leo Bodnar Bu0836X card that I'm trying to make into a comms panel for DCS A-10C but having issues with my rotaries for changing VHF AM/FM and UHF frequencies. I've set them up as 1:4 as suggested (by the way encoders are from eBay - 2bit grey scale with switch although the switch isn't being used). I have set them up as suggested with centre ground and outers to 2 inputs but everytime I turn the knob I get erratic behaviours with all of them - ie doesn't matter which way I turn the knob it rapidly switches between both switch inputs or none at all It's getting confusing for me now. HHHEEELLLPPP Any ideas will be very much appreciated

[claushansen]

Hi

are you using the encoder tool from Leo Bodnar ?

Eg see my site under FSUIPC

Regards
Claus
737sim.dk

[mr_mojo97]

It's ok I got it working now. Although for some reason one of my encoders has started going down 2 increments at a time but increasing in one increment at a time. Any ideas on that? Thanks