Chart board for 737NG

[nax228]

I will make a chart board for my yoke and wonder if anyone knows about a printable pic of the text on the chart board. I will print to a plastic foil and glue it to a black alu plate fixed with a clip.
Top and bottom measurements (cm) of the plate would also be appreciated.


I will try to make a replica of this:

[airbus319]

hello mate

measurements as follows

distance at top 85mm
distance at bottom 55mm

length taken from the middle 180mm

bear in mind that the unit has curved edges so the measurement is taken from the outside of the deges not the inside

cheers

Dave

[tomenglish2000]

Hello.

If you are making your own chart holder this might also interest you.

http://www.737ngproject.be/Yoke.htm

[nax228]

Thanks. I'll start cutting the alu plate after these mesurements.
The 737ng project page was of big interest, but a much larger project then mine. Sure I can pick up this and that from that site.
Still need a good pic of the text bit.

[airbus319]

Also bear in mind that you can buy them relatively cheaply from here mate. best of luck Dave. http://www.aviationmegastore.com/?sh...=355&art=61113

[nax228]

I've found them at aviationmegestore, but since I'm making my cockpit more or less by hand, I would also make this piece. It's done fearly easy I guess.