Results 1 to 3 of 3

Thread: GC Startup

  1. #1
    Executive Vice President, Administration, MyCockpit, Inc.
    Join Date
    Jun 2009
    Location
    Bangalore
    Posts
    260
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    GC Startup

    Dear All

    Everytime GC starts it goes through a routine and checks and confirms the open GL configuration before it commences the saved screen.

    Is there any method by which I can make GC to stop this start up routine?
    Regards
    Vybhav


  2. #2
    10+ Posting Member
    Join Date
    Jul 2008
    Location
    The Netherlands
    Posts
    13
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: GC Startup

    Hallo Vybhav,

    I think you mean that you do not want the benchmark to be run every time you start up the GC?

    If this is so, you just have to change the "Benchmark=On" to "Benchmark=Off" in your PFD.INI file where you installed the GC software. (Most likely in C:\PFD).

    I hope my answer helps you!

    With kind regards,

    Lefranc Loupias

  3. #3
    75+ Posting Member
    Join Date
    Nov 2005
    Location
    Bombay, India VABB
    Posts
    83
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Re: GC Startup

    hi -

    As far as I know, The benchmark test will run only if GC/WideFS does not detect FS running = if FS is running and Widefs is config ok, PM GC will go directly to the last PFD/ND/EICAS combo....

    fc

Similar Threads

  1. As a good startup
    By Spatate in forum Where to Start Building a Home Cockpit
    Replies: 2
    Last Post: 02-04-2009, 05:51 PM
  2. Pmsystem startup
    By mmakela in forum PMSystems
    Replies: 0
    Last Post: 12-22-2008, 12:23 PM
  3. Apu startup
    By John Hansen in forum PM General Q & A
    Replies: 1
    Last Post: 02-12-2007, 10:38 PM
  4. Apu startup
    By John Hansen in forum PM General Q & A
    Replies: 1
    Last Post: 02-12-2007, 10:22 AM
  5. Startup problems..
    By Tom Stian Bjerk in forum PM General Q & A
    Replies: 2
    Last Post: 01-29-2006, 06:53 PM

Tags for this Thread