My first laser cut panel

[glider_uk]

This is the first panel I have cut and engraved to allow illumination of the text.
It is the Fuel Panel for the A10C.


Any comments would be appreciated

Glider

[mondo50m]

Comments? What comments? I mean, other than it looks fantastic, and 'job well done!" what other comments would apply? Great job Is this your first project, or have you had the laser for a while? Again, great job.

Milt

[glider_uk]

Comments? What comments? I mean, other than it looks fantastic, and 'job well done!" what other comments would apply? Great job Is this your first project, or have you had the laser for a while? Again, great job.

Milt

This is my first project myself, But I have done panels for a few people to help them out.

[autocadplease]

I think it looks great. It took me many tries before seeing anything like yours.

[glider_uk]

I am testing a different setup, I am painting the face and then engraving through the paint, I have tested the engraving so it only engraved 2 microns deeper than the paint. It seems to work without leaving any decearnable feel to the engraving . I will re-cut the full panel once testing for fumes from the paint is completed and I will video the cutting and upload it if anybody is interested.