Results 1 to 3 of 3
-
03-11-2009, 07:30 AM #1
Part instalation of PM with FS9 & PMDG
Could anyone help?
I have a simpit XP, FS2004, (PMDG 737-800) and all is working fine at present, I was looking at the overhead guages that can be purchased from various departments and became quite exited that they could all be daisy-chained and work from one controller board, yes the adds said that it interfaces with Fs 2004 too!
Great, but in very small writing at the bottom of the add it says "must have PM software installed".........mmmm new there would be a catch!
I undersatnd that PM is supplied in modular form (please correct me if I am wrong), if so can just the Overhead module be purchased in order top run the various guages without interfearing with anything else?
I know the probable answer will be........eerrrrr NO.
Any help/tips/pointers would be appreciated.
Daveanne
-
03-11-2009, 08:57 AM #2
Try the PMSystem demo . It's free.
Should/could work, partially at least.
It will interact with FS only.
Besides PMSystem(as far as I know because I tried it but do not use it) is very flexible and can be edited if you are better than I am with software.
Try the Demo.
JackJackpilot
B737-700 Posky
FS9/P.Magenta
without PMSystem
-
03-11-2009, 09:34 AM #3
Check this old post.
Video on page 5
http://www.mycockpit.org/forums/showthread.php?t=13213Jackpilot
B737-700 Posky
FS9/P.Magenta
without PMSystem
Similar Threads
-
SIOC MCP 737 PMDG with PMDG 747 in fsx displays and leds don't work
By dion73 in forum Computer Hardware SetupReplies: 7Last Post: 04-03-2011, 07:02 AM -
Order of software instalation
By docmeister in forum Computer Hardware SetupReplies: 1Last Post: 03-02-2010, 05:19 PM -
Gray low part
By pogo in forum General Builder Questions All Aircraft TypesReplies: 2Last Post: 05-06-2007, 01:53 PM -
NEW FMC!! REAL PART!
By dodiano in forum General Builder Questions All Aircraft TypesReplies: 0Last Post: 03-01-2006, 05:41 PM
Search Womans from your town for night
HDG preselect function