Results 1 to 3 of 3

Thread: AML switches

  1. 01-11-2005, 06:24 PM #1
    imported_Nihad
    imported_Nihad is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Dec 2004
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    AML switches

    Question I am using momentary AML switches on my MCP and was wondering if its not possible to give this switch 2 commands so it can stay on in FS2004 when pushed and when pushed again turns off
    Any help on this would be appreciatte it

    regards,

    Nihad
    Reply With Quote Reply With Quote
  2. 01-12-2005, 04:05 AM #2
    imported_MattO
    Guest
    Depends on what software you are using. I e.g. use PM and the following code works for me with momentary switches, such as the AML switch.

    [FCU_SET_LOC]
    offset=4F2
    Length=4
    FSType=Digital
    OffValue=0
    OnValue=28

    Hope this answers your question.

    Matt O.
    Reply With Quote Reply With Quote
  3. 01-12-2005, 07:33 AM #3
    imported_Nihad
    imported_Nihad is offline
    Our new friend needs to reach 10 posts to get to the next flight level
    Join Date
    Dec 2004
    Posts
    8
    Contribute If you enjoy reading the
    content here, click the below
    image to support MyCockpit site.
    Click Here To Contribute To Our Site

    Hi Matt,

    I am trying to figure out all this so sorry about that.
    With the code u just added in your reply do u use that in the fs2phidget? and yes I own the PM software too.
    If not if u could please tell me where this code needs to be added.

    regards,

    Nihad
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. EEC Switches AFT OVH
    By Tony in forum Cockpit Parts and Motion Platforms
    Replies: 1
    Last Post: 08-19-2009, 12:26 PM
  2. Switches?
    By Drewsta in forum I/O Interfacing Hardware and Software
    Replies: 5
    Last Post: 07-21-2008, 10:06 AM
  3. switches and more switches...
    By Jackpilot in forum Cockpit Parts and Motion Platforms
    Replies: 0
    Last Post: 01-10-2008, 06:18 PM
  4. switches?
    By Brenton Hill in forum I/O Interfacing Hardware and Software
    Replies: 8
    Last Post: 12-20-2007, 08:16 PM
  5. Toggle switches to momentary switches?
    By Patrik in forum Where to Start Building a Home Cockpit
    Replies: 5
    Last Post: 10-23-2007, 09:58 AM