Hi all,

I have updated my TQ page to include wiring of servos and to disconnect power to them when AT is off. I have used 3 small relays from Rapid and connected them via USBOutputs card to control when power is on or off based on the status of the AT Offset.

I will upload the SIOC code when I have finished testing it as I have rewired the whole TQ to replace a servo. WHile it was out I replaced all the cheap Pots with better quality ones and added 2 DSUB 25pin plugs to allow swift disconnection and removal in the future. very tidy job if I say so myself.

Regards,
John
www.boeing737ng.co.uk